Metabo HPT N 5024A2 Manuel D'instructions Et De Sécurité page 18

English
4. Maintenance chart (Page 18)
5. Operator troubleshooting (Page 19)
CAUTION
● In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
SERVICE AND REPAIRS
● Only service
metabo HPT, distributor or employer
shall repair the Stapler.
● Use only parts supplied or recommended by
metabo HPT for repair.
Maintenance chart
ACTION
Drain air line fi lter daily.
Keep lubricator fi lled.
Clean fi lter element and blow air
through fi lter in direction opposite
to normal fl ow daily.
Clean magazine and feeder
mechanism.
Keep push lever working
properly.
Lubricate the Stapler after
stapling.
Drain air compressor daily.
18
WARNING
personnel trained
Prevent accumulation of moisture and
dirt.
Keep the Stapler lubricated.
Prevent clogging of fi lter with dirt.
Prevent a jam.
Promote operator safety and effi cient
Stapler operation.
Extend the Stapler life.
Keep the Stapler operated properly.
All quality Staplers will eventually require servicing or
replacement of parts because of wear from normal use.
NOTE:
Specifi cations are subject to change without any
obligation on the part of metabo HPT.
by
WHY HOW
Open manual petcock.
Fill with metabo HPT pneumatic tool
lubricant.
Follow manufacturer's instructions.
Blow clean daily.
Blow clean daily.
Supply 5 – 10 drops of lubricant into
the Stapler.
Open petcock on air compressor tank.