Publicité
Les langues disponibles
Les langues disponibles
English
4. Case
* Outer dimensions
525 × 346 × 236 (mm)
APPLICATIONS
Cutting of rebar
Bending of rebar
PRIOR TO OPERATION
WARNING!
Before use, check the following items. Concerning items
1-7, always be sure to check them before plugging the
power cord into the receptacle.
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
Also, avoid using DC power or engine generators.
Not only will the tool get damaged but an accident
can result.
PICTGRAPH ILLUSTRATION AND
EXPLANATION
Read handling
instructions before use.
Begin operation only after
ensuring that there are no
people within the turning
range of the material to be
bent.
9
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
CAUTION:
Damaged cord must be replaced or repaired.
4. Preparation
environment.
Check and confirm if the workplace is in proper
conditions as mentioned in the general operational
precautions item 1.
5. For safety sake, use the provided Allen key to make
absolutely sure that the hexagon socket bolt is
securely clamped. Use of the unit with the bolt in
a loosely clamped condition can result in damage
to the unit and cutter as well as accidents.
6. Confirm that the cutter is in sharp condition.
Make certain that the cutter is in a sharp condition.
Continued use of a worn out and deformed cutter
with dull edges results in damage to the unit and
cutter as well as accidents.
7. Check plug receptacle.
If a receptacle jounces or a plug comes out easily
when a power cord is plugged in, the receptacle
needs to be repaired. Consult the nearest electric
service station for repair. Continued use of the
defective receptacle can result in overheating and
accidents.
Do not this electric
power tools in wet
wether conditions.
Never bring your
hand close to the
cutter during
operation.
and
confirmation
If the switch is turned off and then
immediately turned on again, the motor
may not start. Wait for at least one full
second before attempting to turn the motor
on again after it has been switched off.
Avoid any work exceeding
the maximum capacities.
(Rebar diameter ø16 mm.)
of
working
Publicité
