Hama Moments 100 Mode D'emploi page 6

Note - automatic connection
and possible problems
After the devices have been paired
once, the connection is then
established automatically. If the
Bluetooth connection is not established
automatically, check the following:
• Check the Bluetooth settings of your
terminal device to see whether hama
selfie is connected. If it is not, repeat
the steps described above.
• Check whether obstacles are
impairing the range. If so, move
the devices closer together.
• Low battery charge can impair the
connection. Fully charge the battery
if necessary.
• Only one Bluetooth device can be
connected at a time. If there is an
active connection to another
• device, deactivate this connection
and try again.
6.2. Remote release function
• Once you have established the
Bluetooth connection, open the camera
function on your terminal device and
select the desired camera (front or rear
camera), if applicable.
• Mount the smartphone in the bracket
(5) and ensure that it is secure.
• Extend the Bluetooth Selfie Moments
100 telescopic pole to the desired
length.
• Press the release button (4) to
trigger the selected function (selfie,
photo, video).
7. Care and Maintenance
Only clean this product with a slightly
damp, lint-free cloth and do not use
aggressive cleaning agents. Make sure
that water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability
and provides no warranty for damage
resulting from improper installation/
mounting, improper use of the product
or from failure to observe the operating
instructions and/or safety notes.
5