Beko BTS 114200 Mode D'emploi page 18

7 Troubleshooting
Please review this list before calling the
service. It will save your time and money.
This list includes frequent complaints
that are not arising from defective
workmanship or material usage. Some
of the features described here may not
exist in your product.
The refrigerator does not operate.
• The plug is not inserted into the
socket correctly. >>>Insert the plug
into the socket securely.
• The fuse of the socket which
your refrigerator is connected to
or the main fuse have blown out.
>>>Check the fuse.
Condensation on the side wall of the
fridge compartment
COOL CONTROL and FLEXI ZONE).
• Door has been opened frequently.
>>>Do not open and close the door
of refrigerator frequently.
• Ambient is very humid. >>>Do not
install your refrigerator into highly
humid places.
• Food containing liquid is stored in
open containers. >>>Do not store
food with liquid content in open
containers.
• Door of the refrigerator is left ajar.
>>>Close the door of the refrigerator.
• Thermostat is set to a very cold level.
>>>Set the thermostat to a suitable
level.
(MULTIZONE,
17
• Compressor is not running
• Protective thermic of the compressor
will blow out during sudden power
failures or plug-out plug-ins as the
refrigerant pressure in the cooling
system of the refrigerator has not
been balanced yet. The refrigerator
will start running approximately after
6 minutes. Please call the service if
the refrigerator does not startup at
the end of this period.
• The fridge is in defrost cycle. >>>This
is normal for a full-automatically
defrosting refrigerator. Defrosting
cycle occurs periodically.
• The refrigerator is not plugged into
the socket. >>>Make sure that the
plug is fit into the socket.
• Temperature settings are not made
correctly. >>>Select the suitable
temperature value.
• There is a power outage.
>>>Refrigerator returns to normal
operation when the power restores.
The operation noise increases when
the refrigerator is running.
• The operating performance of the
refrigerator may change due to the
changes in the ambient temperature.
It is normal and not a fault.
EN