VINCENT SV-700 Manuel D'utilisation page 29

1
3 4
1. INPUT: Input Selector
This dial allows you to choose one of the six
inputs.
2. VOLUME: Volume dial
This is the knob for the adjustment of the main
volume level of the system.
3. CLASS A:
amplifier circuitry mode
This button toggles between modes Class A and
Class AB. Helpful, if the warming of the unit
during better sounding Class A mode is to be
avoided. Allowed to be switched while music is
being played back.
4. Infrared remote control receiver
FRONT VIEW
5
6
5. Input selection LEDs
6. POWER
7. SPEAKER A/B
2
The LED that is actually lit shows you what input
channel has been selected. Additionally these
LEDs show that the appliance is switched on and
not muted.
This is the main power switch for turning on and
off the device. The preamplifier is separated from
the mains voltage when switched off and cannot
be set into a standby state.
If suitable speakers are used, a second loudspea-
ker can be operated at the same time. This button
allows each of the speakers (designated A and B)
to be individually switched on and off. The LED
located above each of the buttons shows which of
the speakers is activated.
7
Vincent
29