Vacuum Cleaning - Dirt Devil Rebel 70 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
DD 7700.book Seite 9 Freitag, 19. Oktober 2012 12:02 12
2 Use
2.1 Assemble appliance and adjust nozzles to surface
2
Use
1
2
click!
click!
6
7
WARNING:
Danger of injury! Only attach the appliance parts when the appliance is
not connected to the power supply. Otherwise the machine might start
up and parts of your body, hair or pieces of clothing might be sucked in.
CAUTION:
Before assembling, make sure that the fitted nozzle suits the surface to
be cleaned. Do not clean e. g. any floors or objects with a brush with
rotating bristles that you would not clean without a second thought with
a conventional brush. Also observe the flooring manufacturer's recom-
mendations.

2.2 Vacuum cleaning

12
11
WARNING:
Danger of injury! Check appliance and power cord before each use. A
damaged appliance must never be used.
CAUTION:
Only use the appliance with all filters undamaged, in dry condition and
correctly fitted. Make sure that no objects obstruct the telescopic tube,
the suction hose or other openings.
1. Pull the cable out of the appliance (Fig. 11) and plug into a socket.
WARNING:
Danger of electric shock! If the red marking shows retract the cord by
pressing the retraction button ( ) to pull in the cord up to the yellow
mark (Fig. 12) again.
2. Switch on the appliance using the on/off switch ( ) (Fig. 13).
3
4
9
8
NOTE:
You might have to twist the parts when connecting them so they are
securely in place. Ensure that installed parts are secure by trying to pull
them apart.
1. Assemble the appliance and accessory parts depending on the surface
you want to vacuum clean (Fig. 1 – 8).
2. Ensure that the bypass vent is closed (Fig. 5).
3. If you use the telescopic tube (Fig. 6), set its length (Fig. 7).
4. If you use the floor nozzle (Fig. 8), set it to the floor to be vacuumed
(Fig. 9 hard floor, Fig. 10 carpet).
13
14
3. Set the power to the setting that corresponds to the cleaning task. (Fig.
14).
NOTE:
The auxiliary air regulator (Fig. 5) must be completely closed for vacuum
cleaning. With the auxiliary air regulator you can quickly reduce the suction
power, to release objects (such as curtains) that have been sucked in.
4. Vacuum clean (Fig. 15).
WARNING:
Danger of injury! Especially when vacuum-cleaning stairs make sure
that you always stand on a higher level than the appliance.
NOTE:
Your vacuum cleaner has an integrated protective function that triggers
before the appliance can overheat (e.g. due to blocked suction paths or
a full dust filter bag), Chapter 4.1, 'Before you send in the appliance'.
5
10
15
9

Publicité

Table des Matières
loading

Table des Matières