Flex FX1151 Manuel De L'utilisateur page 16

WARNING
product damage due to a short circuit, never
immerse your tool, battery pack or charger
in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
VARIABLE-SPEED TRIGGER SWITCH
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the
variable-speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
This Drill Driver/ Hammer Drill must be used only with the battery packs and chargers listed
below:
2.5Ah 5Ah
FLEX FX0111 FLEX FX0121
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
(FIG. 14)
If any parts are damaged
or missing, do not operate
Battery Pack
8Ah
FLEX FX0221
Fig. 14
Variable-Speed
Trigger Switch
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
12Ah
FLEX FX0231
-16-
To prevent accidental
starting that could cause
Charger
FLEX FX0411 FLEX FX0421