Activating The Service Mode - Sartorius Signum Notice D'installation

Activating the Service Mode

e
)
k k
setup
)
wp-1
k
code
)
)
(
code
(
Switch on the display and control unit and press )
briefly, during the startup routine, to open the operating menu
Select the Setup menu item
1
Open the Setup menu
Select the Code menu item
(Press k repeatedly until code is displayed)
Open the Code submenu and enter the service access code (see Appendix)
Enter the code using the ( ) k p keys
Confirm the service access code
Service mode is active: an "S" is shown in the upper right-hand corner of the display.
Return to the "Code" menu, now in service mode.
Return to the "Setup" menu, now in service mode.
1
If password input is prompted at this point, enter the service access code (see appendix)
and confirm input to continue
11