Velleman DVM2000 Notice D'emploi page 3

DVM2000 – HIGH-ACCURACY TRUE RMS MULTIMETER - 50000 COUNTS
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, don't
install or use it and contact your dealer.
2. Safety Instructions
This multimeter has been designed according to IEC-1010-1 concerning electronic measuring instruments with an overvoltage category CAT III 1000V
and pollution 2. This multimeter complies with 89/336/EEC, 73/23/EEC and 93/68/EEC.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not accept responsibility for any
ensuing defects or problems.
• Check the meter before every use. Never use a damaged or deformed multimeter.
• Do not use the multimeter in an environment with combustible gases, steam or dust.
• Always be careful when handling voltages > 60VDC or > 50VAC RMS. Always keep fingers behind the guards. Keep your body insulated when
measuring.
• Never measure voltages exceeding 1000VAC or 1000VDC to ensure your safety.
• Replace the batteries when the
• Repair and calibration must be carried out by experienced professionals only.
DVM2000
symbol appears. Disconnect the measuring probes from any circuit before opening the multimeter.
3 VELLEMAN