Publicité
Les langues disponibles
Les langues disponibles
CR99 Receiver - Front Callouts
1
1.
Antenna Jacks - The front BNC antenna jacks allow full rotation for optimum place-
ment. In normal operation, both antennas should be placed in a vertical position.
2.
VOLUME Control - This knob sets the level of the audio signal being output through
both the balanced and unbalanced output jacks on the rear panel. Reference level
is obtained when the knob is turned fully clockwise (to its "10" setting).
3.
LCD Display - Displays transmitter and receiver settings.
4.
GROUP Button - Press and release button to cycle through the available groups. Press
and hold button to scan for available channels within the selected group.
5.
CHANNEL Button - Press and release to cycle through available channels within a
group. Press and hold button to enter IR Set which is used to set the operating
channel of the transmitter.
6.
POWER Button - Press and hold to turn the CR99 power on and off.
7.
IR Transmitter - During "IR SET" an infrared light is used to set the transmitter
channel.
Receiver Display
A.
Group - Displays the selected group
B.
Channel - Displays the selected channel
C.
Frequency - Indicates the operating frequency
of the selected Group and Channel.
D.
Antenna Indicator - Indicates the active
antenna (A or B).
E.
Transmitter Battery Level - Indicates the
battery level of the transmitter.
F.
Audio Meter - Indicates the strength of the
incoming audio signal.
G.
RF Signal Meter - Indicates the strength of
the incoming radio signal.
6
2
3
D
F
G
4
7
5
6
A
B
1
E
C
Publicité
