BaByliss PRO 4rtists Mode D'emploi page 9

head assembly out of pac-
kage. Align the replacement
foil head assembly over the
cutters. Carefully move the
replacement foil head assembly
down towards the shaver unit
until it firmly snaps into place.
BE CAREFUL NOT TO DAMAGE
THE FOIL OR CUTTERS WHILE
INSTALLING.
TO REPLACE CUTTERS
NOTE: Always replace the cutters
and foil head assembly at the same
time.
1. To remove cutters, place your
fingers on each side and gently
pull up and away from drive
shaft.
2. To replace cutters, remove the
new cutters from the packaging.
Align cutter about the drive
shaft and lightly push down
until it snaps into place.
3. Replace the foil head assembly,
turn shaver on to ensure it is
working properly.
GOOD
BAD
Daily maintenance:
1. Press the release button on the
side of shaver and remove the
head assembly (see Fig. 1 & 2).
2. Use cleaning brush to whisk
away any debris on and around
cutter (See Fig. 3).
3. Snap the head assembly closed
(see Fig. 4).
Fig. 1
Fig. 3
Weekly Maintenance:
1. Repeat steps 1 – 3 from the Daily
Maintenance cleaning steps.
2. Rinse the head of the shaver
under running water (see Fig.5).
NEVER submerge the shaver in
water.
3. Leave head open for drying.
4. Press the shaver head back into
place (see Fig. 4).
9
Fig. 2
Fig. 4