Checking The Calibration - Pioneer SGY-PM900H90 Mode D'emploi

Checking the Calibration

Check that the sensors were calibrated correctly.
It is necessary to check the calibration of the sensors on both the left and right sides. The right-side pedaling monitor sensor is
used as an example in this description. The procedure to check the left side is the same as for the right side.
1
Refer to steps 1 to 3 on page 37 to attach the calibration weight to the pedal and to attach the level to
the crank arm.
2
While the crank arm is pointed down, adjust the angle of the crank arm until the spirit level shows the
angle is perpendicular.
3
Carefully remove the calibration weight and the calibration pedal bolt.
4
In the sensor screen of the SGX-CA900, tap [Pedaling Monitor R] and then [Force Preview] in order.
5
Confirm that the values that appear on the SGX-CA900 Force Preview are within the range shown below.
•
Tangential Direction Force: 0 ± 3 N
•
Radial Direction Force: 0 ± 3 N
6
Refer to steps 1 to 3 on page 41 to screw the calibration pedal bolt into the pedal hole on the crank and
then hang the calibration weight on it.
EN
45