Before Pairing And Calibrating; Pairing And Calibrating Procedure; Placing The Bicycle In A Secure Work Position; Switching The Modes Of The Cyclocomputer Sgx-Ca900 - Pioneer SGY-PM900H90 Mode D'emploi

Before Pairing and Calibrating

This section describes how to pair and calibrate the pedaling monitor sensor that is installed on the bicycle to the Cyclocomputer
SGX-CA900.
•
See the User's Manual or the User's Guide (online manual) of the Cyclocomputer SGX-CA900 regarding how to operate it.

Pairing and Calibrating Procedure

Use the following procedure to pair and calibrate the product.
1. Placing the bicycle in a secure work position (page 31)
2. Switching the modes of the Cyclocomputer SGX-CA900 (page 31)
3. Pairing the pedaling monitor sensor (page 32)
4. Calibration preparations (page 36)
5. Calibrating a highly precise zero point (page 37)
6. Setting the crank length and calibrating weight (page 39)
7. Calibrating the with a load on the pedals (page 41)
8. Calibrating the zero point (page 44)
9. Checking the calibration (page 45)

Placing the Bicycle in a Secure Work Position

Place the bicycle in a level location, such as on a repair stand or indoor trainer.
Be sure to secure it so that it will not fall while you are working.

Switching the Modes of the Cyclocomputer SGX-CA900

This section explains about switching the modes of the Cyclocomputer SGX-CA900.
1
Press the [START/STOP] button of the Cyclocomputer SGX-CA900 for at least 2 seconds to turn on the
power.
2
After starting the CycloMeter, press the
3
Press the (MENU) button and the
4
Enter "78" in the service code input screen and then tap [Done].
A message appears, and the mode switches to dealer mode.
•
To exit dealer mode, turn off the CycloMeter.
•
The dealer mode is for dealers only. Do not use the dealer mode, doing so if you are not a dealer may damage the product or reduce its
accuracy. Anyone other than a dealer using the dealer mode invalidates the warranty.
(MENU) button.
(BACK) button at the same time for at least 2 seconds.
EN
31