Electric Connection - Bosch HBL6EI23 Notice De Montage Et D'installation

Electric connection

Only a licensed expert may connect the appliance.
The appliance must be installed in accordance with
the latest IEE guidelines (Institution of Electrical
Engineers). The appliance could be damaged if
incorrectly connected.
Make sure that the voltage value of the power supply
corresponds with the value specified on the rating
plate. The rating plate is located on the back of the
appliance. Ensure that the power supply is properly
earthed and that the wiring system in the building can
withstand the load from the appliance.
If the appliance is connected directly to the power
supply, an all-pin isolating switch must be present
with a contact gap of 3 mm.
The method of connection must allow complete
isolation in accordance with the conditions for
overvoltage category III. The earth cable is excluded
from this.
Install the mains cable in such a way that it is not
trapped or squashed. The cable must not come into
contact with cut or sharp edges.
7