Sensor Map; Setting The Brightness - Kerbl 345000 Mode D'emploi

-> Operatn: AUTO
Brghtns: 40
On: 07:00
Off: 21:00
Back
Navigate to a "C I R C T 1" to "C I R C T 4" display, to configure the circuit in question. When you press <- to confirm,
you will come to the configuration screen for the selected circuit:
Select the operating mode with <- to change the value. The -> symbol changes to *. You can now set the desired control
mode for this light circuit using the ^ and v keys. Press <- again to confirm the change of value. The -> symbol reappears.
-> C I R C T 1
C I R C T 2
C I R C T 3
C I R C T 4
Settings
Sensor stgs

9.3 Sensor map

-> C I R C T 1: Sensor1
C I R C T 1: Sensor1
C I R C T 1: Sensor1
C I R C T 1: Sensor1
Back

9.4 Setting the brightness

12.15
c
1
* Operatn: AUTO 2
3
Brghtns: 40
150
On: 07:00
Off: 21:00
Back
12.15
150
To ensure the light control processes the sensor readings
correctly, you must define which sensor influences which
12.15
light circuit. To do this, from the main menu navigate to the
"Settings" submenu, then to "Sensor map".
The screen will look like this:
150
You can connect up to four sensors to the light control.
Determine which sensor is to be used to control which
circuit.
38
12.15
c
1
-> Operatn: DIM 2
3
Brghtns: 40
150
On: 07:00
Off: 21:00
Back
c
1
2
Setup
3
-> Sensor map
Button
Time
Lang.
Back
c
1
2
3