Publicité
Les langues disponibles
Les langues disponibles
UK │ 11. Mounting
11.2 Unit mounting
1. Switch off power supply circuits, position a
visible sign warning against being
accidentally switched back on.
2. Pull the rotary knob [2] off.
3. Remove the cover [1] (4 screws).
4. Secure housing [6] to wall with 4 screws.
Suitable mounting material is to be
supplied by the customer.
NOTICE
Danger of short-circuits caused by damp
if the connection cable is not inserted in
the housing correctly.
Ensure that the rubber seals on the PG
screw connection tightly surround the
cables.
5. Feed the connection cables into the
housing through the PG screw
connections. Secure the connection
cables with the PG screw connection.
6. Connect up the connection cables
as shown in the wiring diagram (
Chapter 16, page 12). Check the wiring
and if necessary, tighten the screws in the
connection terminals.
7. Remount the cover [1] (4 screws) and refit
the rotary knob [2]. Make sure that the
rotary knob shaft [5] is not damaged and
that the rubber seal fits tightly round the
shaft and housing edge.
8. Install the fan(s) in accordance with the
operating instructions. Switch the mains
fuse on.
8
12. Start-up
1. Check that the technical data has been
adhered to rating plate.
2. Set the setpoint temperature using the
rotary knob [2].
3. Run function test.
13. Cleaning
1. Clean the housing and the temperature
sensor regularly using a dry cloth.
14. Fault rectification
Fault rectification should only be carried
out by a trained electrician.
15. Disassembly and disposal
Dismantling should only be carried out by
a trained electrician.
The unit and the packaging contain parts that
can be recycled, and should not end up in the
domestic waste.
Dispose of the packaging material in an
environmentally-friendly way, in compliance
with the regulations valid in the country where
you are.
At the end of its service life, dispose of the
unit in an environmentally-friendly way, in
compliance with the regulations valid in the
country of use.
Publicité
