Publicité
Les langues disponibles
Les langues disponibles
1. Locate area that can support the wall seat when mounted to the partition.
2. Measure up 33" (84 cm) from the
This locates the position for the top left attachment hole.
3. Align hole in top left corner of wall seat with mark on partition and hold in
place.
4. Using a level and measuring tape, mark the remaining three (3) holes. After
marking holes, set wall seat down on ground.
5. Use a power drill and 3/8" bit to drill four (4) holes through partition a
mounting points.
6. From opposite side of partition, insert four (4) T-nuts into mounting holes.
7. Align holes in wall seat with drilled holes and secure top left corner of wall
seat to partition using a machine screw and
Continue to secure the three (3) remaining corners using the machine
screws and
washers into the T-nuts (Fig. b).
•
All 4 of these locations MUST be used for safe installation.
8. Ensure all four (4) screws are tight and snap caps over screw heads.
NOTE: Operate seat three (3) or four (4) times to ensure proper function.
OPERATION:
Rotate base downward. Place infant on top of the changing surface. Use restraint system as described below. After child has
been changed, remove restraint system and rotate base back up against the wall.
USE OF RESTRAINT SYSTEM:
Place child on wall seat. Place restraint system over child shoulders and buckle between child's legs. Insert buckle tongue
into buckle and snap together. To tighten or loosen straps, slide adjuster up or down strap. To remove restraint system, press
sides of buckle to release tongue and pull tongue out of buckle.
MAINTENANCE AND CLEANING:
Check all hardware and components monthly or as required to ensure hardware is tight and there are no missing or damaged
components. Take unit out of service if any component is missing or damaged and contact customer service to order
replacement parts. Do not substitute parts. For replacement parts, contact customer service at 800 BRADLEY (800 272 3539).
Clean by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use any strong chemical cleaners or
cleaning agents that may be hazardous to children.
INSTALLATION
and mark the partition (Fig. a).
washer into the T-nuts.
WARNING
2
Top
8"
8 1/2"
(203 mm)
(216 mm)
33"
(84 cm)
Fig. a
A. F. F
Flat
Washer
Machine
Screw
Wall Seat
P20-214 Rev B ECN 16-15-047 04/04/2017
16-5/16"
(414 mm)
Fig. b
Publicité
