Publicité
Les langues disponibles
Les langues disponibles
ADULT INSTALLATION REQUIRED.
TOOLS REQUIRED:
Level (A)
Measuring tape (B)
Power drill with 3/8" bit (C)
Power screwdriver with bull nose phillips bit (D)
•
READ ALL INSTRUCTIONS BEFORE ASSEMBLY OF WALL SEAT.
•
Unpack carton and identify all parts.
Parts Description
Hardware for installation:
1/4 - 20 x 1-1/4" Machine Screws
1/4" Flat Washers
1/4 -20 x 9/16" T-Nuts
1-1/4" Caps
1/4 - 20 x 1-1/4" Machine Screws
IMPORTANT:
The enclosed hardware is for through-bolt mounting on a
1" thick steel partition only. If mounting unit on a partition
of different thickness or on a wall, provide the appropriate
backing and hardware.
-
Wall seat MUST be mounted in a convenient location at
or near the same height as the toilet tissue dispenser. If
mounting in a changing room, mount so bottom of wall
seat is approximately 20-1/2" from the
there is adequate clearance in front of the seat for safe
operation.
• The wall seat is no stronger than the anchors or walls to which they are attached and, therefore, MUST be firmly secured
in order to support the weight they are intended to support.
• Check mounting hardware at least once a month to ensure screws are tightly fastened.
• Always secure a child with restraint system. NEVER leave child unattended.
• DO NOT mount to a door.
• The installer is responsible for confirming the wall construction, anchors, and fasteners are in good condition and
capable of withstanding 200 pounds pull out force or greater. Contact the building architect or engineer for confirmation
when in doubt.
ASSEMBLY INSTRUCTIONS
PARTS LIST
1/4" Flat Washers
Make sure
WARNING
1
A
C
1/4 -20 x 9/16" T-Nuts
A.D.A. Compliance:
307.2 Maximum Protruding Objects
308.2 Forward Reach
308.3 Side Reach
309.4 Operation
Compliant when properly installed.
P20-214 Rev B ECN 16-15-047 04/04/2017
B
D
Quantity
4
4
4
4
1-1/4" Caps
Publicité
