KitchenAid KUDC10 Instructions D'utilisation page 8

OPTION SELECTIONS
OPTIONS
Cleans pans, casseroles,
etc., with tough food soil to
eliminate the need for
soaking and scrubbing of
dirty, baked-on dishes.
Raises the main wash
temperature to improve
cleaning for loads
containing tough, baked-on
food.
Sanitizes dishes and
glassware in accordance
with National Sanitation
Foundation (NSF)/ANSI
Standard 184 for Residential
Dishwashers. Certified
residential dishwashers are
not intended for licensed
food establishments. The
Sani indicator indicates at
the end of the cycle whether
the Sani Rinse option was
successfully completed. If
the indicator is not
activated, it is probably due
to the cycle being
interrupted.
Dries dishes with heat. This
option with the use of rinse
aid will provide the best
drying performance. Plastic
items are less likely to
deform when loaded in the
top rack. Turn Heat Dry off
for an air dry.
Runs the dishwasher at a
later time or during off-peak
electrical hours. Select a
wash cycle and options.
Press 4 HOUR DELAY. Press
START/RESUME. Close the
door firmly.
NOTE: Anytime the door is
opened (such as, to add a
dish), the Start/Resume
button must be pressed
again to resume the delay
countdown.
Control Lock Avoids unintended use of the dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Control Lock, press and hold for 3 seconds. The Control Lock light will stay on for a short time, indicating
that it is activated, and all buttons are disabled. If you press any button while your dishwasher is locked, the light
flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked.
NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL, or by opening and
closing the door before you are able to turn Control Lock off.
To turn off Control Lock, press and hold for 3 seconds. The light turns off.
8
CAN BE WHAT IT DOES
SELECTED WITH
Heavy Duty Activates the
ProScrub
Normal Wash
jets to provide
intensified cleaning
power to items at
the back of the
lower rack.
Heavy Duty Raises the main
wash temperature
Normal Wash
from 105°F (41°C)
to 145°F (63°C) and
the final rinse from
130°F (54°C) to
140°F (60°C).
Heavy Duty Increases the main
wash temperature
Normal Wash
from 105°F (41°C)
to 145°F (63°C) and
the final rinse from
140°F (60°C) to
155°F (68°C).
Available with any Activates the
cycle except Rinse heating element at
the end of the wash
Only
cycle to speed
drying times. Heat
Dry defaults to ON
when any cycle is
selected except for
1 Hour Wash.
Available with any Delays the start of a
cycle up to 4 hours
cycle
ADDED TIME TO
CYCLE
TYPICAL
45
® spray
45
60
52
240
.
ADDED
WATER
GALLONS
MAX
(LITERS)
85 0 - 1.6
(0 - 6)
85 0 - 1.6
(0 - 6)
105 0 - 1.6
(0 - 6)
52 0
240 0