Dogtra RB 1000 Série Notice D'utilisation page 32

Receiver Battery Charging Receptacle and Rubber Plug
On the inside of the receiver/collar, next to the collar strap, is a
battery-charging receptacle with a rubber plug.
Internal Antenna in the Receiver/collar
Dogtra RB 1000 Series has a non-exposed antenna that is located
inside the receiver/collar.
60
CHARGEUR DE BATTERIE
Charging Cable
Two-dog unit only
The battery charger and charging cables allow you to charge both
the transmitter and receiver at the same time. The battery charger
is designed for a 220-volt wall outlet (10-volt field charger
for Lithium- Polymer batteries for your automobile are also
available.).
To use the battery charger for the two-dog unit, combine both sets
of battery charging (splitter) cables as shown. This enables you to
charge the transmitter and both receivers at the same time.
NOTE : Only use Dogtra-approved Lithium-Polymer Battery
Chargers for your Dogtra beeper collar. This will prevent
any damage that can be incurred from attempting to use
a dif ferent chargerThe battery charger.
220 volt
Charger
Wall Outlet
61