Table des Matières
Publicité
installation guide
STEP 6
Uncoil the Power Cord and connect to the Power Supply.
Place Power Supply on the ground and extend from
the base.
Ensure that the Power
Supply and all attached
cords are directed
toward the desired
surge protector.
STEP 7
Carefully flip the base over on to its legs.
Important: Two people are required to move the bed
base. Do not drag across the floor. Do not rest frame
on its side, excessive pressure may damage the legs.
STEP 8
Plug the base into a power source. A surge protector is
strongly recommended.
WARNING
Always unplug the base from the electrical outlet before servicing any
part of the base. To reduce risk of electric shock, unplug the base before
cleaning. To safely disconnect, ensure the base is in a flat position with all
motors off, and unplug from power source.
Always use two people when setting up the base
STEP 9
Ensure batteries are correctly installed in the back of
the remote.
Quickly test functions to verify proper setup before
placing mattress on base. Press FLAT to return the
base to a flat position.
STEP 10
Locate the mattress retainer
bar slots. at the foot of the
base.
Insert the left end of the
mattress retainer bar into the left
slot, then insert the other end
into the right slot to secure the
bar.
Basic setup is now complete!
7
Publicité
Table des Matières
