Pair Remote - beautyrest SmartMotion Base 1.0 Manuel Du Propriétaire

pair remote

The original remote that comes in the box is already paired to the bed base. No further action is required.
In the event that the remote is not paired with the base, follow the steps below.
STEP 1
Remove back cover from remote
control. Remove and replace
batteries.
STEP 2
Double click the button on the
Power Down Box (this will not
cause the base to move). The
light will illuminate.
•
Remove back cover of the remote, locate the rubber button in the center of the back.
•
On the control box located underneath the bed, double click the RESET button, light will illuminate.
•
Press and hold the back rubber button on the remote. The button will begin to flash then become a
continuous solid light and then turn off.
•
Once the remote is paired, replace back cover of the remote and test base functionality.
STEP 3
Press and hold button on the back
of the remote. The light will begin
to flash then become a continuous
solid light and then turn off.
STEP 4
Both lights on the Power Down Box
and the Remote will be continuous,
then simultaneously turn off.
Replace back cover of the remote.
The remote is now paired with the
base.
If the Power Down Box is not available :
11