ROWENL19-Notice735360:ROWEN224
3 • Storing and transporting
the appliance
After use, stop your appliance by pressing on
the on/off pedal and unplug it
Replace the cable by pressing the automatic
cord winder pedal
Thanks to its carrying handle, your vacuum
cleaner is easy to move around
CARE AND CLEANING
IMPORTANT
your appliance before maintenance or
cleaning.
CAUTION
cleaner without the filtration system (pts 2, 3
and 4).
1 • Emptying the dust collector
Empty the dust box as follows after each use
and/or cleaning of the HEPA filter:
• Press the "eject" button to unlock the dust
(fig.11)
box
.
• Remove the dust box and place it above the
(fig.11)
dustbin
• Press the "push" button on the dust box
(fig.12)
and empty it
• Clean the seals of the dust box using a dry
(fig.13-14-15)
cloth
• Again close the dust box and replace it on
the appliance
CAUTION
Do not fill above the max. level
shown on the dust compartment.
*Depending on model:
this is either equipment specific to certain models or available as an optional accessory.
13/06/08
(fig.6)
(fig.7)
.
(fig.8)
.
Always turn off and unplug
Do not operate the vacuum
.
.
.
(fig.16)
.
14:59
Page 28
When you tidy away your vacuum cleaner
(always in the horizontal position
you can place the tube in its storage space to
the rear of your appliance in the storage
.
(fig.10)
position
.
IMPORTANT
cleaner in the vertical position
2 • Automatic cleaning of the
HEPA filter
If your vacuum cleaner is equipped with the
HEPA automatic cleaning system, cleaning
will
be
automatic
intervention from you. It will start if
necessary on plugging in your vacuum
cleaner.
If your vacuum cleaner produces a clicking
noise during cleaning, this is completely
(fig.17)
normal
.
REMARK
If you notice weaker suction
from your appliance, you can impose HEPA
filter automatic cleaning. To do so, stop your
appliance and press the on/off pedal twice in
succession with your hand
each cleaning cycle.
IMPORTANT
28
(fig.9)
Never stow your vacuum
(fig.9)
.
and
requires
(fig.18)
after
Then empty the dust box.
),
no