Rowenta Clean Power RO7539 Mode D'emploi page 32

ROWENL19-Notice735360:ROWEN224
3 • Maintaining the HEPA filter
IMPORTANT
cleaned at least once a year.
IMPORTANT
satisfactory after automatic cleaning of the
HEPA filter (see Cleaning and Maintenance
paragraph), it must then be cleaned manually.
IMPORTANT
damaged, you can obtain a replacement
from your retailer or Certified Service
Centres under reference ZR003401.
Remove the lid of the separator
unscrew the separator
from its location.
Clean the inside and outside of the separator
(fig.21-22)
using a cloth
Remove the HEPA filter
Rinse the HEPA filter in water under the tap
(fig.24)
.
Do not put water in the HEPA filter .
Allow the filter to dry for at least 24 hours
before replacing it
TROUBLESHOOTING
IMPORTANT
cleaner starts to malfunction, and before
performing any checks stop the appliance by
pressing the Start/Stop switch.
If your vacuum cleaner does not start
• The appliance is not plugged-in. Check that
the appliance is correctly plugged in.
If there is no suction
• An accessory, the tube, the flexible tube or the
pipe between the suction inlet (pt 12) and the
separator are blocked: unblock them.
• If the separator is clogged, remove the lid
(fig.19)
and clean the separator.
13/06/08
The HEPA filter should be
If suction is no longer
If your HEPA filter is
(fig.19)
(fig.20)
to remove it
.
(fig.23)
.
(fig.24)
.
As soon as your vacuum
14:59 Page 29
CAUTION
Do not touch or rub the folds of
the HEPA filter. Allow the HEPA filter to dry
completely before replacing it on the
appliance.
Replace the HEPA filter in its case
and screw in the separator
Again close the separator lid firmly
4 • Cleaning your vacuum
cleaner
Clean the housing of the vacuum cleaner
with a soft and humid rag and let dry with a
(fig.28)
dry rag
Wash the dust compartment in clear water,
then dry it with a dry cloth.
and
IMPORTANT
aggressive or abrasive products. The
transparency of the dust compartment
and/or the separator cover may change in
time but this
performances of the appliance.
• If the HEPA filter is saturated, see page 28 and
29 paragraphs 2 and 3. If the HEPA filter is
damaged, replace it (Ref. ZR003401).
If the suction of your vacuum cleaner has
dropped, it makes a noise and whistles
• An accessory, the tube, the flexible tube or the
pipe between the suction inlet (pt 12) and the
separator are partially blocked: unblock them.
• If the dust box is full, empty and clean it (see
paragraph 1).
• The separator cover is not correctly in place.
Close the separator cover correctly
29
(fig.25)
(fig.26)
.
(fig.27)
.
Do not use detergents, or
does not affect the
(fig.27)
GB
.
.