Installation/Mounting - Rockford Fosgate PUNCH PMX-HD9813 Mode D'emploi

• Contents
• Source Unit
• RCA Output Harness
Installation Considerations
The following is a basic list of tools needed for installation:
• Volt/Ohm meter
• Battery post wrench
If you feel unsure about installing this system yourself, have it
installed by a qualified Rockford Fosgate dealer.
Before installation, disconnect the battery negative (-) terminal to
prevent damage to the unit, fire and/or possible injury.
For your specific radio installation, please refer to www.
rockfordfosgate.com/products/details/pmx-hd9813 for more
information.
If installing this unit in a motorcycle that no longer has the factory
radio harness and connectors or if adding rear speakers to a
motorcycle not equipped with them, please contact Rockford
Fosgate to purchase the harness (part # 1130-72997-01).
Red
White
Red
White
(Aux In Right) Red
(Aux In Le ) White
• Installation & Operation
Manual
• T-25 Torx Bit
• 3/16" Allen Wrench
Rear Output (Black)
Front Output (Grey)
Aux Input (Red)
Mounting
This unit is a direct plug and play replacement for the factory
radio.
1. Using your Torx tool, remove the fairing screws securing the
outer fairing to the bike. This will give you access to the factory
radio.
2. Remove the (4) factory screws that are holding the radio in
place using the 3/16" allen tool. There are (2) on each side.
3. Carefully unplug the factory harness and antenna from the
back of the factory radio.
4. Remove the radio by pulling it towards the front of the
motorcycle.
5. Slide the PMX-HD9813 source unit into the factory radio
mounting hole and secure with existing factory fasteners.
6. Plug the factory harness and antenna into the back of the new
unit.
7. If using a non Rockford Fosgate amplifier, plug the RCA harness
into the remaining socket. See illus-1.2.
8. If using an AUX to plug into the unit, plug the RCA harness into
the remaining socket. See illus – 1.2.
9. If installing a SiriusXm Connect Tuner and antenna, you must
plug the SXV300 tuner into the SiriusXm port. See illus 1.2
10. If using the Rockford Fosgate amplified kit, please refer to the
video on www.rockfordfosgate.com/motorcycle
11. Reinstall the fairing onto the bike.
Remove the screw to
access RCA harness
plug.
Sub Output (Purple)
Remote Trigger (Blue/White)
5
Installation / Mounting
Red
White
illus.-1.2