Publicité
Les langues disponibles
Les langues disponibles
9
• Locate the mattress board and four (x4) M6 X 2cm screws.
• Place the mattress board into the frame lining up the four through
holes with the plastic mattress board support nuts.
• Using a screw driver and four (x4) M6 X 2cm screws, tighten the
mattress board onto the plastic mattress board supports.
10
Mobile Attachment
Holes
• Locate the fabric liner.
NOTE: Front of the frame has the mobile attachment holes and the front
of the liner has the warning label.
• Align the mobile attachment holes with mobile attachment opening on
the warning label end.
• Place the liner onto the frame. Make sure warning in centered at the
end of bassinet.
11
Snaps
• Stretch the pockets on the bottom of the liner around the ends of the
mattress support.
Customer Service
Tel. (800) 218-2741
Bassinet Assembly
Mattress Board
*Not Actual Size
M6
Top Rail
Mattress
Pocket
Support
12
• Lift the skirt on the liner, snap all of the straps around the top of the
frame.
13
Mattress Pad with sheet
• Place the sheet over the mattress pad.
• Place the mattress pad with sheet into the liner.
14
Canopy Ratchet
Hook and
Loop Patch
• Position the canopy over the top end of the bassinet opposite the
warning label.
• Push aside foam to expose metal and push the canopy ratchet onto the
frame on both sides of the bassinet.
•
Fasten the hook and loop fasteners on the back edge of the canopy to
the liner. Then fasten the hook and loop patches on each canopy flap
to the side of the liner.
6
Frame
www.SimmonsKidsProducts.com
Publicité
