Working With The Electric Power Tool; Acoustic Warning Signal - Festool AGC 18 Notice D'utilisation D'origine

English
► Press and hold the locking lever on the
guard.
► After passing the pressure point, turn
the guard forwards.
► Remove the guard from the power tool.
8.6 Fitting the guard/cutting guard [9]
NOTICE
Signs of wear on the cutting guard.
► Before switching on the sanding tool, check
that it can move freely. The sanding tool
must not sand against the cutting guard.
Use the guard provided for the application
in each case.
► Insert the guard in the front position.
Make sure that the position of the pin and
groove match.
► Turn the guard to the required position
until the locking lever engages automatical­
ly.
To fit the sanding tool, see section
9 Working with the electric
power tool
WARNING
Risk of injury
► Only guide the power tool into the material
when it is switched on (running).
► Always secure the workpiece in such a
manner that it cannot move.
► Keep your hands away from the rotating
sanding tools.
WARNING
Risk of injury from the fragile sanding tool
► Ensure that the sanding tool's expiry date
has not been exceeded.
WARNING
Risk of injury due to moving workpiece
► Ensure that the workpiece is secure.
WARNING
Risk of injury from overhead work
► Always wear safety glasses for overhead
work.
► Wear a P2 respiratory mask.
24
► Remove the sanding tool from the power
9.1
For sanding, always use the guard supplied
with the tool.
The guard is preassembled. For how to remove
the guard, see section
9.2
For abrasive cutting, always use the TSH-
AGC 18-125 cutting guard that is available as an
accessory.
The cutting guard is fitted, positioned and re­
moved in the same way as the guard, see sec­
tions
► Always guide the sanding tool through the
8.2 .
► For thick-walled workpieces, make a sepa­
9.3
Risk of eye injuries caused by flying parts/
wires
► Wear protective goggles.
For working with wire brushes, always use the
HS-AGC18 hand protection that is available as
an accessory, see section

10 Acoustic warning signal

If the power tool switches off because of subse­
quent operating statuses, no warning signal
sounds when it switches on.
Battery pack not accepted
–
Battery pack empty
–
–
Battery pack fault
–
–
Battery pack overheated
When not in use, the power tool can be set
down on the support points [1-11].
tool for transport.
Sanding
8.5
Abrasive cutting
8.5 and 8.6 .
workpiece in a straight line.
Ensure that the sanding tool does not tilt
and that it is not loaded at an angle or from
the side.
rating cut using oscillating movements
while applying slight pressure to the power
tool.
Working with wire brushes
WARNING
Insert the correct battery pack model.
Change the battery pack.
Charge the battery pack.
Change the battery pack.
Use the charger to check that the battery
pack is fully functional once it has cooled
down.
.
8.3 .