System > System Info; System > Restore Default - Tech Line DVRC 800 Mode D'emploi

DF-H3F12S-RL-W(GB) 2007.9.10 12:52 PM
System > System Info
'System Info' helps service personnel identify key
firmware information about your DVD Recorder + VCR
in case service is required.
System
System > System Info
˘ ` 29 mac001
System Info
†
Restore Default
Confirm Back Exit
ENTER MENU SETUP
Version
FD300007TCU-070716
Loader Version
BH07T A100
Micom Software
02.09
Confirm Back Exit
ENTER MENU SETUP
1200DPI 100LPI
System > Restore Default
If you wish, you can reset the DVD Recorder + VCR to
its original factory settings.
1 While 'System' is selected, press [†] to select
'Restore Default'.
2 Press [ENTER].
3 The 'Restore Default' menu will appear. Use
[.../†] to select 'OK' and press [ENTER].
System
System Info
Restore Default
Confirm
ENTER MENU
Restore Default
Do you want to Restore Default?
OK
• Some options cannot be reset, including
Parental Controls and Password.
• After Restoring Defaults, the unit is powered off
automatically. At this time, if you power on
again, the Installation menu appears. You
must set the country, language, channel, and
clock settings again.
Setup menu
†
Back Exit
SETUP
Cancel
29