Publicité
Les langues disponibles
Les langues disponibles
Setting the Clock
To set the current time:
1. Press and hold Time Set (
) until you hear a beep.
2. Use the |7 8|buttons to change the time.
3. Press Time Set (
) to accept the change.
Using the Alarms
Your Logitech Pure-Fi Anytime
includes two separate alarms.
™
Alarm State
To enable an alarm: press alarm 1 (
) or alarm 2 (
To disable an alarm: press alarm 1 (
) or alarm 2 (
Note: If an alarm is enabled, the alarm indicator for that alarm will be visible on the display.
Alarm Settings
To set the alarm settings:
1. Press and hold alarm 1 (
) or alarm 2 (
2. Alarm time: Press the |7 8| buttons to change the time.
3. Alarm source: Press Source (
) to select the alarm source. Options are: iPod, AM, FM, and buzzer.
4. Alarm volume: Use
/
or the volume
Notes
• To immediately exit from alarm set mode, press alarm 1 (
• If iPod is the selected alarm source, Logitech Pure-Fi Anytime
(for Alarm 1) or "Alarm 2" (for Alarm 2) in shuffle mode when the alarm occurs. If no "Alarm 1" or "Alarm
2" playlist exists, Logitech Pure-Fi Anytime
™
Logitech Pure-Fi Anytime
will randomly play music from the entire iPod library.
™
5
English
). This will also show you the alarm time.
).
) for 1 second.
/
buttons on the remote to select the alarm volume.
) or alarm 2 (
).
will launch the playlist named "Alarm 1"
™
will resume the current playlist. If there is no current playlist,
Snooze
Using the snooze feature will temporarily turn off an active alarm for several minutes – allowing you to get a few
more minutes of sleep. To activate the snooze feature:
• Press Snooze (
) OR
• Wave your hand above the speaker (the motion sensor will activate snooze automatically)
Note
• To set the length of the snooze timer, hold the snooze button (
press the |7 8|buttons to change the snooze length.
Resetting an Alarm
Resetting an alarm turns it off for the rest of the current day – and automatically turns it on for the following day.
To reset an alarm, do either of the following:
• Press Power (
). This will also turn the speaker off. OR
• Press Source (
). This will keep the speakers on and switch to the selected source.
Notes
• An alarm can only be reset if it is either active or snoozed. (Pressing either alarm button if no alarm is active
will toggle the alarm state rather than reset it.)
• An alarm will only sound for 60 minutes before automatically resetting itself.
Backup Battery
Your Logitech Pure-Fi Anytime
includes a backup battery to keep your Logitech Pure-Fi Anytime
™
during a power outage. The backup battery performs three functions while the power is out:
• It keeps the clock time correct
• It will remember your radio presets
• It will sound the alarm
The display will indicate when the battery is low or dead or not installed.
Notes
When using the backup battery:
• The alarm will always sound the buzzer, regardless of the alarm source setting.
• You cannot listen to the iPod or the radio.
• The display brightness will be at the lowest setting.
) down until you hear a beep. Then,
working even
™
6
English
Publicité
