Remington F4790 Mode D'emploi page 9

ENGLISH
When empty, the battery will be fully charged around 120 minutes for the F4790, F5790,
F6670 and the F7790, to provide 60 minutes (F4790, F5790, F6790, F7790) of shaving time.
The shaver adapts automatically to a mains voltage between 100V and 240V.
CORDED USE
Connect the shaver to the adapter, then to the mains and recharge for 5 min. before using.
CAUTION:
Extended mains only use will result in the reduction of the battery life.
HOW TO USE
SHAVING
Make sure your shaver is properly charged
Begin by removing the protective head guard from your shaver.
Switch the shaver on.
Slide the pop-up trimmer up and use to remove long hair first. Then slide down when
finished. (Fig. D_E)
Stretch the skin with your free hand so the hairs stand upright.
Hold the shaving head so all foils touch your skin simultaneously. The independently
floating foils automatically adjust to the contours of your face. Only apply light pressure on
the shaving head whilst shaving and use short, circular strokes. (Fig. F)
After shaving turn the shaver off.
To shave without the head pivoting sytem, slide the trimmer up to the first position.
TRIMMING
Completely retracted (down), the trimmer is out of the way and off, for when you want
to use the screens alone. Press the trimmer button down with your thumb to get it into
this position.
In the middle position, the trimmer locks the pivoting head.
Fully extended (up), the trimmer can be used to trim your sideburns and moustache. It can
also works with the screens, cutting the longer, hard-to-shave hairs so the screens can get
extra close.
TIPS FOR BEST RESULTS
Ensure your skin is dry. Always hold the shaver at right angles to the skin so that both foils
are touching the skin with equal pressure. Use moderate to slow stroking movements. The
use of short circular motions in stubborn areas may obtain a closer shave, especially along the
neck and chin line. DO NOT hold the shaver at an angle whereby only one foil is touching the
skin. This will distort the foil and may cause the cutters to damage the foil. DO NOT press
hard against the skin in order to avoid damage to the foil.
090248_REM_IFU_F4790_5790_22L.indd 3

21:05:03|17.04.09 Guido Krölls