Installation - AddEnergie CoRe+ Guide D'installation

Système de rappel des câbles
Masquer les pouces Voir aussi pour CoRe+:
Table des Matières

Publicité

AVANT DE COMMENCER
!
En déballant le système de rappel, assurez-vous de retirer la vis
de fixation qui a servi à retenir le contrepoids durant le transport .
¡
Installation de nouvelles bornes de recharge côte à côte
Installez d'abord le piédestal . Reportez-vous au CoRe+ MC
Guide d'installation pour piédestal .
Préparez ensuite le matériel d'installation des supports à
borne de recharge côte à côte et des systèmes de rappel, et
suivez les instructions qui sont présentées ci-dessous .
Installez enfin les bornes à recharge . Reportez-vous au CoRe+ MC Guide
d'installation .
Installation sur des bornes de recharge côte à côte existantes
Mise en garde
: Avant de commencer, interrompez le courant pour éviter toute
décharge électrique .
INSTALLATION SUR DES BORNES DE RECHARGE EXISTANTES
1 .
Désinstallez les deux bornes de recharge du piédestal afin d'être en mesure
de poser les nouveaux supports à borne de recharge côte à côte et les deux
systèmes de rappel .
2 .
Défaites le câblage puisqu'il vous faudra brancher les bornes à de nouveaux fils
électriques .
3 .
Préparez ensuite le matériel d'installation des supports à borne de recharge côte
à côte et le système de rappel et suivez les instructions qui sont présentées ci-
dessous .
4 .
Réinstallez les bornes de recharge sur les nouveaux supports .
Prévoyez du 30 cm (10 po) de câblage électrique supplémentaire afin de
pouvoir raccorder la borne de recharge dans sa nouvelle installation.
BEFORE GETTING STARTED
!
When unpackaging the Cable management system, make sure to
remove the security screw used to hold the counterweight during
transport .
¡
Installing new side-by-side charging stations
First, install the pedestal . Refer to CoRe+ MC Installation
Guide for pedestal .
Then, prepare installation material for the side-by-side
charging station mount brackets and Cable management
systems, and follow the instructions that are indicated below .
Finally, install the charging stations . Refer to CoRe+ MC Installation Guide .
Installing on existing side-by-side charging stations
Caution :
Before getting started, cut off the current to prevent an electric shock .
INSTALLATION ON PRE-INSTALLED CHARGING STATIONS
1 .
Remove both charging stations from the pedestal so that you can install the new
side-by-side charging station mount brackets and the two Cable management
systems .
2 .
Remove the wiring as you will need to hook the charging stations to new wires .
3 .
Then, prepare installation material for the side-by-side charging station mount
brackets and Cable management systems, and follow the instructions that are
indicated below .
4 .
Reinstall the charging station on the new brackets .
Allow 10 «(30 cm) of additional electrical wiring to connect the new charging
station to the installation.
© 2016 ADDÉNERGIE TECHNOLOGIES INC. TOUS DROITS RÉSERVÉS Les informations et les spécifications contenues dans ce document sont sujettes aux changements, modifications et ajouts à n'importe quel moment et sans préavis.
© 2016 ADDÉNERGIE TECHNOLOGIES INC. ALL RIGHTS RESERVED Information and specifications contained in this document are subject to change, amendments and additions at any time, without notice.
15

Publicité

Table des Matières
loading

Table des Matières