Marq GAMUTPAR H7 Guide D'utilisation page 4

Setup
Note: Items not listed under the Introduction > Box Contents are sold separately.
Power Information
Before connecting the fixture to a power outlet, make sure the power cable is not crimped or damaged. Also,
make sure the power outlet's voltage is within the range stated on this product (on its housing or decal).
Before cleaning or replacing the fuse, disconnect Gamut PAR H7 from its power source. Use a
screwdriver or other tool to remove the compartment (do not pull it out by the tab only). Replace the fuse
only with a new fuse with the same rating (3 A).
Mounting/Rigging
Place the fixture on a flat, stable surface. Make sure all cables are secured and placed so that no one will
trip over them.
Linking
When using multiple Gamut PAR H7 fixtures, you can link ("daisy-chain") them so that each each fixture
supplies power and/or sends DMX data to the next one. This helps reduce clutter in your cabling and save
you setup time.
You do not have to link fixtures for both power and DMX control; you can link them for either purpose
independently. For instance, you could link 8 fixtures together for DMX control while linking only 4 of those
same fixtures together for power (powering the other 4 fixtures separately).
Power
Use a standard IEC power cable to connect the Power Out of one fixture to the Power In of another. As
long as the first fixture is connected to a power outlet, any of the linked fixtures can remain off and still
supply power to the next one.
Important: To prevent undue damage to your fuses, we recommend linking no more than 6 fixtures at 100–
120 V or 14 fixtures at 200–240 V in the same chain.
Gamut PAR H7 Gamut PAR H7 Gamut PAR H7
Power
DMX
Use a standard 3-pin DMX cable to connect the DMX Out of one fixture to the DMX In of another. Your
connected DMX controller will send its data to the fixtures in sequence. All fixtures in this chain will receive
all DMX data.
Gamut PAR H7 Gamut PAR H7
DMX controller Gamut PAR H7
4