Marq GAMUTPAR H7 Guide D'utilisation page 3

Features
Bottom Panel
1. Power In: Use a standard power cable (included)
to connect this input to a power outlet.
2. Power Out: Use a standard power cable to
connect this output to an additional fixture. This
connection will supply power to the additional
fixture when this one is connected a power
outlet. Please see
information about linking multiple fixtures.
Note: On models sold in the USA, this will be a
standard "Edison" (NEMA) connection. On other
models, this will be a standard IEC connection.
3. DMX In: Use a standard 3-pin DMX cable to
connect this input (A) to your DMX controller or
(B) to another fixture that will pass DMX data
through it to this one. Gamut PAR H7 receives
DMX data over this connection. Please see
Setup > Linking > DMX
linking multiple fixtures.
4. DMX Out: Use a standard 3-pin DMX cable to
connect this output to an additional fixture.
Gamut PAR H7 sends its data to an additional
fixture over this connection. Please see
Linking > DMX
multiple fixtures.
Rear Panel
1. Display: This display shows messages and
values indicating the fixture's current status.
2. Menu: Press this button to access Gamut PAR
H7's menu.
3. Up: Press this button to select the next-highest
menu option or to increase the value by 1.
4. Down: Press this button to select the next-lowest
menu option or to decrease the value by 1.
5. Enter: Press this to confirm your current
selection or value.
Setup > Linking > Power
for information about
for information about linking
for
Setup >
4 3 2 1
1
2 3 4 5
3