Quick EBSN Série Mode D'emploi Et D'installation page 8

CHARACTERISTICS - INSTALLATION
GB
ELECTRONIC SWITCH FOR THE BILGE PUMP
This electronic switch permits the bilge pump to be switched on in the presence of water.
The advantages offered by the EBSN are:
• Operation managed by microcontroller.
• Advanced digital filter to distinguish the presence of water.
• Extended power supply range.
• Remote indication of operation status by led or remote control panel (optional).
• Manual remote pump switch-on by button or remote control panel (optional).
• Signal for prolonged bilge pump switch on (if led or remote control panel is installed).
• Protection against excessive battery rundown.
• Switch-on/switch-off delay to avoid false switch-on/switch-off cycling of the pump caused by the roll of
the boat.
• Functioning over a wide range of environmental temperatures.
• Resin-coated watertight casing.
• Easy installation.
INSTALLATION
BEFORE USING THE EBSN, READ THIS INSTRUCTION MANUAL CAREFULLY. IF IN DOUBT, CONTACT
YOUR NEAREST QUICK
QUICK ® electronic switch for the bilge pump has been designed and constructed for the purposes descri-
bed in this instruction manual. The Quick
damages caused by improper use of the instrument, or by incorrect installation or by possible errors in
this manual.
ANY TAMPERING WITH THE EBSN BY UNAUTHORIZED PERSONS WILL VOID THE GUARANTEE.
THE PACKAGE CONTAINS: EBSN - user's manual.
INSTALLATION OF THE EBSN ELECTRONIC SWITCH FOR BILGE PUMPS
Install the right EBSN for the maximum current rating of the pump under work conditions.
Install the EBSN in vertical position with the power supply cable facing upwards and then fasten it to the
support by screwing two screws into the two lateral slots. These two slots permit the correct adjustment
of the sensors' height as regards the draught of the pump. Adjust this height in such way that a complete
drainage of the compartment occurs during the 20 seconds of pump disabling delay.
WARNING: if the EBSN must be fastened to electrically conductive metal walls, particular attention
must be paid to the fastening screws (and any washers/brackets used), which must be made in
non-electrically conductive material.
8
® RETAILER OR CUSTOMER SERVICE.
®
company shall accept no responsibility for direct or indirect
EBSN 10-15-20 - REV001A