Telcoma Automations T21 Instructions D'utilisation page 36

GB
TAB. 2
Terminal Terminal
Device
n. n.
1 2 Line
3 4 Lamp
4 5 Flashing light
6 5 Motor
7 5 Motor
8 Aerial Rx
9 Aerial Rx
10 11 Auxiliary circuits
13 12, N.O. pushbuttons
17,21
14 12, N.O. pushbuttons
17,21
15 12, N.C. contact
17,21
16 17, N.C. contact
12,21
18 17, Contact (table 1)
12,21
19 21, N.C. contact
12,17
20 21, N.C. contact
12,17
Input Output
All N.C. inputs (normally closed) not used in the control unit must be shorted with the common.
All N.C. contacts associated with the same input must be connected in series.
All N.O. contacts (normally open) associated with the same input must be connected in parallel.
For the control unit power supply, the INSERTION OF AN EXTERNAL DISCONNECT SWITCH (not supplied) is
envisaged, which must be independent and sized according to the load.
36
V I max Function
Control unit power supply
230Vac 6,3A
Courtesy light (mod. T31)
230Vac 0,5A
Movement indicator
230Vac 0,5A
Closes
230Vac 5A
Opens
230Vac 5A
Braid
Control unit
Power supply
24Vac 200mA
Step-by-step (Open)
Pedestrian (Close)
Stop
Photocell
Closing edge
Opening limit switch (mod. T31)
Closing limit switch (mod. T31)
Notes
Connect to 230 Vac line. See electrical connections.
Lit from starting of manoeuvre until 3 minutes after complete
closure.
Flashing during manoeuvre. It can activate in advance (pre-
flashing) see dip switch functions n. 5.
Max 1000VA
Max 1000VA
If a receiver is connected to the connector, see the aerial
characteristics required by the manufacturer.
Enables powering of photocells or auxiliary devices.
See "Step-by-step and Pedestrian input mode" tab. 3 (dip-
switches n. 1 and 2).
See "Step-by-step and Pedestrian input mode" table 3 (dip-switches
n. 1 and 2). The partial opening time can be programmed
All functions shut down.
Connect this input to the common if it is not used.
During the closing manoeuvre it reverses direction. Connect this
input to the common if it is not used.
During the closing manoeuvre it reverses direction. When this
input is NOT used, connect the 8.2K resistance (table1).
Connect this input to the common if it is not used.
Available only on model T31
Connect this input to the common if it is not used. Available only
on model T31.