Rane DRZH Guide D'utilisation page 5

Installation
DRZH can be mounted in a standard 1-gang US electrical box:
1. Run a shielded Ethernet cable (Cat5e or Cat6) from the audio
processing unit to the electrical box, and then connect it to the RJ45
port on DRZH's rear panel. DRZH can be located up to 300 meters
(984 feet) from the processing unit.
2. Use the included screws to secure the DRZH rear housing to the
electrical box and wall.
Note: A minimum 1/4" diameter by 1" depth (6.35 x 25.4 mm) pilot
hole is required for the included wall anchors.
3. Make sure the knob has been removed, then place the faceplate
over the DRZH housing and reattach the knob.
1-gang US
Electrical Box
Screws
DRZH Rear
Housing
Knob
DRZH
Faceplate
5