Black Max BM80917 Manuel De L'opérateur page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 To remove the nozzle, pull back the quick-connect collar,
remove the nozzle, then push the collar forward again.
Place nozzle in the nozzle storage area on the top of the
machine.
WASHING WITH DETERGENT
See Figure 20.
Use only detergents designed for pressure washers; house-
hold detergents, acids, alkalines, bleaches, solvents, flam-
mable material, or industrial grade solutions can damage
the pump. Many detergents may require mixing prior to use.
Prepare cleaning solution as instructed on the solution bottle.
 Place the injection hose in the bottom of the detergent
bottle/container.
 Install the black nozzle on the spray wand.
 Spray the detergent on a dry surface using long, even,
overlapping strokes. To prevent streaking, do not allow
detergent to dry on the surface.
Before shutting off the engine:
 Place the injection hose in a bucket of clean water.
 Flush for 1-2 minutes (spray clear water through the spray
wand).
 Shut off the engine.
NOTE: Shutting OFF ( O ) the engine will not relieve pressure
in the system. Pull trigger to release water pressure.
OPERATION
RINSING WITH THE PRESSURE WASHER
 Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 Remove the nozzle by placing hand over nozzle then
pulling back the quick-connect collar. Place nozzle in the
nozzle storage area on the top of the machine.
 Select the right nozzle for the job:
• Use medium pressure nozzle (green) for items such as
a car or boat.
• Use higher pressure nozzle for jobs such as stripping
paint and degreasing the driveway. When using these
nozzles, test a small area first to avoid surface damage.
 Start at the top of the area to be rinsed and work down,
overlapping the strokes.
MOVING THE PRESSURE WASHER
See Figure 21.
NOTE: Never lift this product using the transport handle.
 Turn the pressure washer off.
 Lift the handle so that the feet are off the ground, then
roll the machine to the desired position.
Page 11 — English

Publicité

Table des Matières
loading

Table des Matières