Publicité
Les langues disponibles
Les langues disponibles
to 2h, the Led_4h will be off and Led_2h on instead; while the timer countdown to 1h, then
the Led_2h will be off and Led_1h on instead.
When all timer Led is off at last, the device will turn off at once, and enter into standby
state.
ECO mode
In working condition, press the key to enter into the ECO mode, the indicator lights up,
press it again to quit this mode. It is unable to use
30 °C, CO mode), and shift
power (heating powers & cooling power) under ECO mode.
a. ECO mode: The default temperature setting is 18°C and 25 °C.
1. When the ambient temperature is lower than 18°C, the device will work with high
heating power；
2. When the ambient temperature is between 18°C and 25°C, the device will work with
low heating power;
3. When the ambient temperature is over 25°C, the device will stop heating.
b. Under ECO mode: when the ambient temperature is over 25°C with oscillation, PTC
heating element and oscillation will stop working, and other functions keep going on;
then when the ambient temperature goes down 1°C(namely 24°C), PTC, fan and
oscillation motor all will start to work again.
c. Under ECO mode: when the ambient temperature goes up to 18°C, the device will work
with low heating power; and when the ambient temperature goes down 1°C(namely
17°C), the device will turn to working with high heating power.
Notes
Tip-over protection: all functions are unavailable and all Led are off after the device tip
down. And the device will enter standby mode after it is put back a stable floor level.
Continuous electric memory functions
1. After the device is power on and used. Under that situation, press
standby mode. Once you press
key again to shift standby mode to working mode, the
previous operation on the device setting will be kept the same to go on, except the
timer. (like, under the condition high power heating before the device shut down, it will
work for 10 seconds in low power
on when pressing
key again under standby mode.
2. When the device works with no timer, the device will automatically shut down after 12h
count from the last operation on the control panel.
3. Key sounds: there is only
power key sound"BiBi" either on the control panel or on
the remote controller.
temperature setting (22°C, 26°C,
key to enter
at first, then converted to high power with Led_
REMOTE CONTROL
Power button
Temp button
Swing button
HOW TO INSTALL BATTERIES
1. Pull out the battery door at the back side of remote control (see Picture4).
2. Pay attention to the battery polarity, and insert the battery（CR2032 3V）into the tray of
the door (see Picture 5).
3. Push the battery door into the remote control.
Remote control
Battery door
Picture 4
Picture 5
62 | 63
ECO button
Mode button
Mimer button
GB
Publicité
