Oscartielle Nettuno G.E. 100 Mode D'emploi page 19

At the input of the supply, it is necessary to install an omni-polar magnetothermic/differential device with contact opening
equal to 3 mm and adequate cutoff power.
Caution: Before connecting the cabinet to the power mains make sure the supply voltage corresponds to the rating on
the serial number plate (consider that the maximum voltage variations admissible are +/- 10%). Both plug-in and remote
unit cabinets are delivered without the supply cable (FIG. 8), therefore make sure the electric connection is made with
cables of a diameter and length capable of withstanding the power and current absorbed by the display cabinet (TAB. 1).
It is essential not to exceed this length in connecting the cabinet to the wall socket. The cable should be fully extended in
a safe position away from possible impact and at a distance from liquids or water and heat sources. In case of breakage
of the power cable of the cabinet, it must be replaced by the manufacturer or by institution in charge of it. The plug should
be accessible even after installation of the cabinet.
Important: installation should be made following the manufacturer's instructions, by qualified personnel only, in
conformity with the electric safety regulations in force in the country where the cabinet is installed (electric safety
regulations and laws, accident prevention laws, fire prevention regulations, directives).
Always ground the cabinet.
The manufacturer is not liable for any injuries caused by failure to respect this regulation.
If there is no wall socket near where the cabinet is to be installed, provide for connection in conformity with the regulations
in force.
Do not use adapter plugs.
The manufacturer has no liability for any damage to personnel or property caused by improper installation.
7 - Technical features
The cabinet is supplied with a plastic bag containing this manual of instructions that must be kept. It contains technical
data, wiring diagrams and tables concerning the cabinet.
The technical data are also shown on the rating plate (FIG. 9). It indicates:
1. Name and address of the manufacturer
2. Commercial name of the cabinet
3. Cabinet code
4. Cabinet serial number
5. Rating
6. Frequency
7. Max absorbed current
8. Max absorbed power
9. Max absorbed power during defrosting
10. Standard lighting power
11. Net display area
12. Type of cooling gas used
13. Weight of cooling gas loaded in each unit
14. Climatic class and reference temperature (dry bulb)
15. Electrical safety factor
16. Work schedule number
17. Work order number
18. Year of manufacture
19. Heating capacity
20. QR code
21. EAC marking
Important: The rating plate and warning labels should never be removed. The manufacturer is not liable for any damages
caused by failure to respect this regulation.
This is to certify that the product complies with Legislative Decree no. 108 of 25/01/1992 applying EEC Directive 89/109
concerning materials and objects expected to come into contact with food products.
8 - Loading and use of the unit (start-up)
If the cabinet has been greatly tilted during positioning and installation, wait at least three hours before starting it up in
order to give the lubricating oil enough time to collect in the compressor! The refrigerating unit may be irretrievably
damaged if this precaution is ignored.
The display unit can only be started up for the very first time after complying with points 3 and 4 above.
With the unit unplugged, remove the plastic film protecting the insides and outside and then clean (follow the instructions
in point 11 below).
Fit the various shelf supports at the height required. FIG. 1 shows the best distances between shelves.
Plug in the unit (having followed the instructions in point 6) and flip the switch fitted upstream (if any). A slight humming of
the motor and the lighting-up of the display indicate that the unit is powered up.
Switch on the lights using the switch on the decorative front panel (see FIG. 11).
The cabinet is equipped with a display located on the decorative front panel FIG. 11
The electronic control instruction handbook for the displays is attached to the instruction manual. A password guarantees
that these devices cannot be tampered with.
17