Miscellaneous - Medisana FTD Mode D'emploi

GB 3 Measuring procedure / 4 Miscellaneous

4 Miscellaneous

4.1
Cleaning and
maintenance
4.2
Disposal
18
7. The device will then automatically go into time and ambient
temperature mode (if the time was programmed) or switches off.
8. If the measured temperature is outside the permitted range, "Lo"
or Hi" will be displayed.
• The most important and sensitive part of the thermometer is
the sensor . Accurate temperature measurements can only be
guaranteed if the probe is clean and intact.
• The sensor is waterproof and can therefore be cleaned by
directly immersing it in alcohol or using a ball of cotton wool
soaked in alcohol.
• Normal commercial alcohol-based disinfectant is suitable for dis-
infecting the sensor
turer's instructions.
• The housing and the display
waterproof. Do not immerse them in liquids.
• Clean them with a dry, clean cloth. Do not use aggressive cleaners.
• It is advisable to keep the thermometer in the original packing that
it was in when it was purchased, and keep it in a clean, dry place.
Do not expose the thermometer to direct sunlight.
• The storage temperature should be between -20.0°C to +50.0°C.
• The device is calibrated in the factory. Recalibration is not required
for normal use.
This product must not be disposed of together with domestic waste.
All users are obliged to hand in all electrical or electronic devices,
regardless of whether or not they contain toxic substances, at a muni-
cipal or commercial collection point so that they can be disposed of in
an environmentally acceptable manner.
Please remove the batteries before disposing of the device/unit. Do not
dispose of old batteries with your household waste, but at a battery
collection station at a recycling site or in a shop.
Consult your municipal authority or your dealer for information about
disposal.
. Please follow the respective manufac-
of the thermometer are not