OHAUS Scout Mode D'emploi page 4

EN-2
SETUP DEFINITIONS
Menu Settings
PRINT / A. Print – Off
PRINT / A.Print / On.Stable – Load,
Load.Zero
PRINT / A.Print / interval - (xx) sec
PRINT / Auto Print – accept
PRINT / A.Print – Continuous
PRINT / Content
PRINT / Layout / Format - (Single,
Multi)
PRINT / Layout / Feed - (Line, 4
Lines, Form)
Ethrnt / IP Adr
Ethernet Connection
The Interface has a preset IP Address. The Port Number is always 9761 and
cannot be changed. For more Ethernet configuration, please refer to the Section
Ethernet Configuration.
For STX Balances:
Upon installation, the STX balance will show the Ethernet icon (
right corner.
Menu added
Communication
|--Ethernet
|--Ethernet Settings
|--Print Settings
Explanation
Only sends data when PRINT is pressed.
Balance only transmits stable data.
Load: Print stable value excluding zero
Load.Zero: Print stable value including zero
Balance sends data every (xx) seconds.
Balance only sends stable accept data in Check
mode.
Balance repeatedly sends data as fast as
possible.
On: print relevant content after weighing data
Gross – on: G; Net – on: N; Tare – on: T;
Info – on: balance will print application mode
setting parameters
Single: print all data in one line
Multi: print all data in multiple lines
Line: feed one line after printing
4 Lines: feed four lines after printing
Form: feed one page after printing (move to the
top of next page after printing)
Displays the balance's IP Address
Use the "No" and "Back" keys to show the entire
number on the display
Function
For more info, please refer to the STX instruction
manual.
Ethernet Interface
) in the upper