Metabo HPT RB 18DC Mode D'emploi page 16

English
State of lamp Battery Remaining Power
Lights ;
The battery remaining power is
over 75%.
Lights ;
The battery remaining power is
50%–75%.
Lights ;
The battery remaining power is
25%–50%.
Lights ;
The battery remaining power is
less than 25%.
Blinks ;
The battery remaining power
is nearly empty. Recharge the
battery soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully
cool down.
Blinks ;
Output suspended due to failure
or malfunction. The problem may
be the battery so please contact
your dealer.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
Do not give a strong shock to the display panel
or break it. It may lead to a trouble.
BEFORE USE
Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure
that lighting and ventilation is adequate.
16
Table 5
MOUNTING AND DISMOUNTING THE
NOZZLE AND DUST BAG
WARNING
To avoid serious accident, ensure the
switch is in the OFF position, and pull out
the battery.
1. Mounting the NozzIe
Insert the pin located outside the nozzle into
the groove provided on the blast port, and fully
turn the nozzle toward the arrow in Fig. 10 until
a click is heard.
To dismount the nozzle, folIow the above
procedures in reverse.
Nozzle
Pin
NOTE
Before conducting a blowing operation, blow
out air in a location where there is nobody
nearby to make sure the tool is free of any
residue.
2. When using the Blower/Vacuum Cleaner
for dust collection
(1) Mounting the Dust Bag
Mount the dust bag on the blast port, following
the same procedure described above for
mounting of the nozzle (Fig. 11).
Dust bag
(sold separately)
Blast port
Groove
Fig. 10
Blast port
Pin
Groove
Fig. 11