Metabo HPT RB 18DC Mode D'emploi page 15

(1) Select a charging method
Depending on the charge method selected,
either the battery is inserted into the charger or
the power cord is plugged into an outlet.
○ Charging a USB device by battery (Fig. 7-a)
○ Charging a USB device from a electrical
outlet (Fig. 7-b)
○ Charging a USB device and battery from a
electrical outlet (Fig. 7-c)
a
(2) Turn the USB power switch ON (Fig. 8)
When you turn the USB power switch ON, the
USB power indicator lamp will light up.
Rubber cover
USB cable
USB port
(3) Connect the USB cable. (Fig. 8)
Pull back the rubber cover and fi rmly plug in a
commercially available USB cable (appropriate
to the device being charged) into the USB port.
○ When the power cord is not plugged into an
outlet and the battery runs out of power, power
output will stop and the USB power indicator
lamp will shut off .
○ When the USB power indicator lamp goes out,
change the battery or plug the power cord into
an electrical outlet.
b
Fig. 7
USB power
switch
USB power
indicator lamp
Fig. 8
(4) When charging is completed
○ The USB power indicator lamp will not go
out when a USB device has been completely
charged.
To verify charge status, check the USB device.
○ Turn the USB power switch OFF and unplug the
power cord from the electrical outlet. (Fig. 8)
○ Remove the battery from the charger and place
the rubber cover over the USB port.
ABOUT REMAINING BATTERY
INDICATOR
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to
light the indicator lamp. (Fig. 9, Table 5)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is
c
pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
Remaining battery
indicator lamp
Display panel
English
Remaining battery
indicator switch
Fig. 9
15