Medisana SAC Mode D'emploi page 20

GB
2 Operation
2.4
Reset function
14
Off button
If you have activated an alarm but wake up before the set time, you can press
the Off button to turn off the alarm function. The settings of the alarm func-
tion are kept for the next day. If you do not press the Off button
wake up before the alarm time and forget to press the Off button
function is turned off automatically after about 30 minutes.
You can use Off button
Zizz button
If you are taking a short break or what to take a little nap, you can set a short-
time alarm. Press the Zizz button
Pressing the Zizz button
time you press the button, the time until the alarm is extended by 15 minutes.
The maximum alarm time that can be set for a short-time alarm is 90 minutes.
By pressing the Set button
to the alarm at the same time.
In the Zizz function, the setting for sound is preset. If you need to change the
sound, use Set button
alarms manually" section, page 11-12).
Demo/Snooze/Quick Check button
If you are not using the alarm function, that is, if no alarm was activated by
Alarm button , the button
the Demo button . The light gets brighter in 5 second intervals (displayed
levels of brightness 0 – 20). Following that, four sounds of nature are intro-
duced. The entire demo process takes about one minute.
If an alarm has been set but the alarm is not active, you can use the button
to check the settings of the alarm function. Press the Quick Check button
and the entered values appear on the display. Press the button
the Quick Check function.
If you have activated an alarm time, the countdown for it has already started but
the maximum level of brightness has not been reached, you can use the button
for the snooze function. Press the Snooze button
before setting time, the wake up function (including light and sound) will stop
until the setting time. Then it takes only 1 minute for light and sound to reach
the setting degree. If you press the Snooze button
the setting time, the unit will wake up after 5 minutes, and repeat operation
works within 30 minutes. Every time pressing the Snooze button
wake up function for further 5 minutes. The maximum to extend the alarm time
is 30 minutes.
If the device is not working correctly, pull the plug from the power point, wait
10 seconds and then plug it in again. The device switches to the RDS function
to set the time automatically. If no RDS signal is available, reset the time and
the other functions again as described in the "Setting the time and alarms
manually" section, page 11-12.
to close any activated function.
, on the display
once sets an alarm to go off in 15 minutes. Every
you confirm your entry and start the countdown
to change the setting (see "Setting the time and
can be used for the demo function. Press
e.g. if you
the alarm
the Zizz icon appears.
,
again, to end
during 30 minutes and
within 30 minutes after
stops the