Beta 682 Mode D'emploi page 11

INSTRUCTIONS FOR USE
4. After the procedures have been performed, the wrench to certify will appear in the
"sample" folder (Figure 4).
This symbol indicates that wrench must be certified
5. Enter all the data that need to be included in the certificate. The instructions are con
tained in (Figure 5).
Click on "calibration
options" icon
Precision requirements
Quality Manager
Recalibration frequency
Selected wrench to certify
Select Dynatester port
Confirm
Select Dynatester parameters
Progressive certificate number
Certifying body
Laboratory number
Add by clicking "add" to
Dynatester to use
EN
Figure 4
Figure 5
11