LENCO PDR-020 Mode D'emploi page 5

4. Preset
5. Vol-
6. Prev
7. Vol+
8. Next
9. Power/Mode
10. Power on/off switch
11. DC 5V,1A Power connector
12. Charging Light Indicator
13. 3.5mm Headphone Socket
14. LCD display
15. Telescopic Antenna
Instructions
Basic operations
Switch on your DAB Radio for the first time
Slide the OFF/ON switch to the ON position on the back of your DAB radio to power up the DAB
radio.
Extend the telescopic antenna for the best reception possible.
Then press the Power/Mode button to turn the radio on.
When DAB mode is activated for the first time, a full scan will automatically commence, or will play
the last station before the unit was turned off.
Once the radio has been switched ON, press the Power/Mode button to switch between DAB and
FM modes.
During scanning the screen will display a slide bar that indicates the progress of the scan, and the
amount of radio stations that have been found so far. Once the scan has finished, the radio will
select the first alphanumeric station.
Slide the ON/OFF switch to the OFF positin to turn the DAB radio off.
Note: Long press power button and unit will go to standby mode.
Selecting the modes
When the DAB radio is turned on, press the power/Mode button repeatedly to switch between DAB
and FM modes.
Adjusting volume
Press the VOL+ or VOL- button to increase/decrease the volume.
DAB operation
To listen to the tuned stations press either the PREV or NEXT buttons. Each time you press the
PREV/NEXT burrons, you wll skip to the previous or next stored station.
The radio will display the station name.
Store and access up to 10 DAB and 10 FM Station Presets.
Decrease the volume.
Select previous frequency, station, preset station or menu option.
Increase the volume.
Select next frequency, station, preset station or menu option.
While the radio is on, press to switch between DAB and FM modes.
While the radio is on, slide to switch it off. While the radio is off, slide to
switch it on.
5