Tokai TCP-124 Manuel D'utilisation page 19

Press ON/OFF button (11) to cancel the NAP function.
Note: When using the NAP alarm the wake up light function is
inactive.
INDOOR TEMPERATURE
• Indoor temperature sensor is at the back of the unit. The unit
detects the current environment temperature.
• In order to display the indoor temperature in °C or °F, first
turn ON the "AUTO CHANGE DISPLAY CONTENT" (refer to the
corresponding paragraph above).
• During Auto Change display content mode, when temperature is
displayed, press on >> (12) key to toggle between temperature
in Celsius to Fahrenheit.
• The detection range of indoor temperature is between 0°C & 50°C
or 32°F & 122°F.
PROJECTION UNIT
Note: project time image on the ceiling or wall of a darkened room.
The maximum projection distance is 0,90 M ~ 2,70 M.
Focus setting:
- Adjust the brightness & focus of the projected clock by turning the
adjustable focus wheel (18) until the projected time is clearly
shown on the ceiling or wall.
- Adjust projected direction thanks to the angle adjustment.
- Flip the projected image by 180° by pressing 180° FLIP (16)
button.
- To switch from the time projection to the temperature projection,
keep depressed over 2 seconds PROJECTION TIME 180° FLIP/
TIME-TEMPERATURE (16) button.
DIMMER CONTROL
The dimmer switch (6) allows you to set the brightness of the LED
display to high, medium and low 3 levels.
19