Ferm ATM1040 Mode D'emploi page 2

PAINT SPRAY GUN
Read the safety and operating
instructions of the air tool and the
compressor before using the appliance.
Contents
1. Machine data
2. Safety instructions
3. Use
4. Maintenance
1. MAChINe dATA
Technical specifications
Operating pressure
Nozzle diameter
Maximum nozzle flow rate
Container capacity
Weight
2. SAfeTY INSTRUCTIoNS
explanation of symbols
In this manual and/or on the machine the
following symbols are used:
Wear protective gloves
Use a spray-mask during spraying
Wear eye protection
Safety instructions
Always read the user manual of the
compressor and of the objects and/or
materials you use.
• A void too high pressure
• N ever blow or spray in direction of yourself or
others; this could cause serious injury.
• K eep bystanders and pets away
• C hildren and animals should be kept far away
from the area of operation of the machine.
2
• I f you use the compressor to spray paint:
a) D o not work in enclosed spaces or near
naked flames.
b) M ake sure that the environment in which
you will be working has dedicated
ventilation.
c) Protect your nose and mouth with a
dedicated mask
• I f the compressor is no longer in use, always
take the plug out of the plug socket.
• A lways make sure that compressed-air
hoses are used for compressed air and which
are characterised by a maximum pressure
adjusted to that of the compressor. Do not try
to repair the hose if it is damaged.
3. USe
4.5 - 6 bar
1.5 mm
Only use the compressor with accessory in a
6.5 cfm
good ventilated area.
750 cc
0.65 kg
• C onnect the PU hose between compressor
and accessory
• S lide the hose-coupler on the accessory until
the coupler clicks. Now the hose is connected
correctly.
• T o release the coupler, pull the outside ring
backwards.
Use paint spray gun
Paint and solvents are very flammable. Therefore
check the following:
• O nly spray in good ventilated areas
• U se a spray-mask during spraying
• A void open fire and smoking during spraying
• D o not spray in an area with a burning stove
• N ever spray with fuel of other flammable
products
• W ear safety goggles
To obtain the best results, it is important that you
prepare the surface to be sprayed and thin the
paint to the correct viscosity, before you operate
your spray gun. Always ensure that the surfaces
to be sprayed are free from dust, dirt and grease.
Make sure that you have masked the areas that
should not be sprayed, using a good quality
masking tape. The paint or fluid to be sprayed
should be thoroughly mixed and free from lumps
or other particles. Many substances can be
sprayed with your spray gun, but always check