Publicité
Les langues disponibles
Les langues disponibles
To turn on and preheat you bun warmer, just turn on the thermostat control knob (n°1
on picture) on the wished position. The orange pilot light ignites (n°2 on picture) dur-
ing heating. When orange pilot light switches off, the device is ready for use.
Preheating is of about 20 mm.
Thermostat
1
5. FUNCTIONING / MANIPULATION
a) Installation / assembly:
- Unpack carefully the device of its packaging.
- Place the device on a plane and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible
materials even if it is very well isolated.
- A distance of minimum 10 cm with the partition or the wall is necessary.
- Remove the protective film around the machine.
b) First starting:
When heating for the first time, set the thermostat to maximum for approximately one
hour with the container empty. This may emit a slight smell and smoke for a few mo-
ments. This is to be expected because of the new insulator.
Be sure to keep water in the tray at all times. A volume of approximately 30 cl of wa-
ter will be needed.
In order not to soak the small loaves when the drawer is opened, the tray has an anti
-wave cross under the perforated plate.
When small loaves are added during operation, be sure to place the remaining
loaves at the front so as to leave the new loaves sufficient time to warm up.
Do not heat the same loaf several times because it could cause it to take on a disa-
greeable taste.
1
Pilot light
2
2
12
Publicité
