SELFSAT CARAVAN PLUS Manuel Utilisateur page 18

17
Connect the signal cable to the antenna port, place the bottom of the cable holder in a position
that does not interfere with the operation of the antenna, and apply masking tape 5 mm from the
outside of the bottom of the cable holder
18
Drill a hole that the minium size for the cable
can pass through in the center of the tape
marking (16mm or less)
20
Insert the signal cable, cable holder, and cable gland as shown in the picture above, and assemble
it into the cable gland.
21
Place the assembled cable holder inside the
tape marking and drill three(3) of 2mm holes
approx. 30cm
19
Pass the signal cable through the hole (two
cables for twin output)
approx. 30cm
22
Fix cable holder with three(3) of M4 x 20
screws on drill holes made
ENGLISH - 17